Search FAQ & Page

Installation & Setup FAQ

I got a brand new laser, but it won't work. What can I do?

Before calling your vendor our our service line, please check the following points:

- do you use the right operation voltage?
- is the environmental temperature not below 10°C?
- is the interlock connector plugged in (if there is a interlock connector, of course)?
- is the key switch turned to "on"?
- if there is a mechanical shutter: is it moved aside?
- doese the laser only not work in one operation mode (sound, auto, ILDA - as far as the options are available for your unit)?
- if operated in ILDA mode: Do you operate your software properly? (Interface connected, cable properly attached, laser output activated in software, right interface selected for output in software?)
- if operated in ILDA mode: Do you try to project a single beam or a very small pattern? Probably the scan fail safety blocks that (it only does if switched to full block mode! This is not the standard option.)... please try a larger pattern.

Distributed brands:

Distributed Brand LaserworldDistributed Brand tarmdistributed brand Ray Technologies
Distributed Brand Laserworld ShoweditorDistributed Brand Garden StarDistributed Brand SparkBlasterDistributed Brand PangolinDistributed Brand coherentDistributed Brand wireless solutionsDistributed Brand Spider Laser Game

ilda logo black cleanedup 2006 member


Contact us:
ch +41-71-6778080
usa 407-432-7217
en +44-161-8720272

This email address is being protected from spambots. You need JavaScript enabled to view it.
 

You agree to the disclaimer of this page with using it.