Only ShowNET interfaces and the ArtNet controller must be used in the same network. Avoid using other network devices in the same network.
How to calculate DMX values for DIP switches
This calculation tool shall help you in finding the right dip-switch settings for a certain DMX address. The dip switches are set according to binary calculation meaning that every dip switch can feedback only the values 0 and 1. The calculation is comparably simple: Every dip switch has the value 2n where n is the number of the dip switch. First dip switch is 0 (computers start counting from 0, not from 1), so when it's switched on it says 20 = 1. Dip switch 2 has the value 1 if switched on, so it is 21 =2. Third dip switch has 22 = 4, fourth 23 = 8.
To Set a value you first have to find the highest number that fits the value, then you add up smaller values.
Example:
DMX512 value 11 shall be set:
1. Highest number that fits is 23 = 8
2. Second highest number is 21 = 2
3. third highest number that fits is 20 =1
So setting would be: 11010000
Use the DMX512 calculator for easy configuration:
{{dmxswitch}}
Activate ArtNET operation mode with the Admin Tool
2. Change the "Data source for internal DMX effects" to "ArtNet input" as seen in the picture below:
Here are video instructions on the Admin Tool:
3. Click on "Store Data" to save the changes.
4. Confirm the two upoming info-dialogs with click on "OK". Then restart the laser mainboard by switching the power off and back on again.
DMX Modes
Basic mode with some preconfigured animations
Suitable for beginners
Uses 19 DMX channels
Professional mode with advanced features
Needs DMX deep understanding
Uses 34 DMX channels
How to change the DMX mode
DJ mode is the standard option. To use the Professional mode:
- Open the admin tool and navigate to the tab "Settings".
- Change the option under "DMX Operating Mode", as seen in the picture below
- Click on "Store Data" to save your changes.
- Click on "OK" twice and wait until another window opens that asks to restart the ILDA interface. To do so, switch the laser system off and on again.
How to upload ILDA files to the SD card
All the explanation goes here - All the explanation goes here - All the explanation goes here - All the explanation goes here - All the explanation goes here - All the explanation goes here - All the explanation goes here - All the explanation goes here - All the explanation goes here - All the explanation goes here - All the explanation goes here - All the explanation goes here - All the explanation goes here - All the explanation goes here - All the explanation goes here
Distributed brands: